This 2 meter wingspan glider takes 15 minutes to assemble and lasts a lifetime!
The wings and tail are made from tough EPO foam. However, the fuselage is made from a really strong blow moulded nylon skin*, Usually reserved for baby toys, with plywood formers, making it almost indestrucatable.
The virtually indestrucatable fuselage is smooth and ridgid yet still light enough for the glider to perform. Both the main wing and tail are screwed into place and the two wing halves have a carbon fiber rod for added strength.
The main wing requires 1 servo per aileron for strong control surface movement plus there is a pre-moulded slot so you can add your own flaps later. To complete this model you will require 4 9g servos, a 30A speed controller, a brushless outrunner, your own transmitter and receiver (Tx/Rx) and a 1300~1800mAh Lipoly battery.
This really is a super strong glider that takes 15 minutes to put together.
Spec.
Wingspan: 2 meters (78.74inch)
Length: 1160mm
Flying Weight: 980g
Servos: 4 x 9g (Required)
Motor: Brushless 2815/1050Kv (Required)
ESC Included: 30A (Required)
Required.
4 x 9g Servos
2815/1050Kv Brushless Motor with a 3mm shaft
30A ESC
LiPoly 1300~1800mAh 3S
Receiver
Tx/Rx
*Having a blow moulded fuselage on a glider is an excellent solution however it is not popular amongst manufacturers due to its high cost, effectively doubling moulding costs.
Non disp.
