YGE-60

• BNF-RTF Micro Helicopter for VBar Control radio (bind and fly, ready to fly)
• Exceptional flight performance, comparable to larger 600-700 class helis
• Equally suitable for sports flying, aerobatics and 3D flying
• Wide range of head speeds, from 2,500-7000+ 1/min possible
• Lipo 3S-650 mAh battery for flight times from 4-9 min. (included)
• Dual Motor System, direct drive for main and tail rotor
• Dual ESC with metal case
• VBar NEO mini 6.4 Flybarless System with 'Anti Gravity'
• VBar NEO already set up, no setup on your own required, just bind and fly
• VBar NEO Governor with RPM telemetry
• Micro digital servos with metal gears for the swashplate
• Carbon frame and landing gear
• Aluminum rotor head and swashplate
• VTX main rotor blades
• Glass Fiber Airbrush canopy

• This LOGO 200 does not support other radio systems than VBar Control, without further adjustments.
• At your own discretion, you can use VBar Control to select a digital third party protocol as an input, and make the necessary channel adjustments.
• You then obviously also need a suitable separate third party receiver.
• Adjustments to the flight parameters can only be made with VBar Control. VBar NEO mini can not be set up via computer software.
• If set up properly, you can then fly the model with VBar's motor switch logic, three parameter banks, and use Rescue and/or Beginner mode (if installed).

Specifications:
- Rotor diameter: 400 mm
- Rotor blades: VTX 173 mm
- RTF weight: approx. 310 g
- recommended batterie: Lipo 3S-650 mAh (included)
- Main gear ratio: 1
- Tail gear ratio: 1
- Main Gear size: ./.
- Length: 420 mm
- Hight: 135 mm
- Width: 74 mm

Content
Kit LOGO 200 Super Combo ARF
Motors: OMPHOBBY
ESC: OMPHOBBY
VBar electronic: VBar NEO mini VLink 6.4
Servos: 3 x digital micro servo w/ metal gears, OMPHOBBY
Blades: VTX 173 mm
Tail Blades: 71 mm
Canopy Airbrush canopy